HPE Storage Users Group

Hi,

Does anyone know if you can have a 1-N configuration with a single rcip interface for each target array?

Another words if you have a source array with 2 rcip interfaces, can N:S:P 0:3:1 point to array2 and N:S:P 1:3:1 point to array3?

I was hoping this was possible but when I try and 'add to configuration ' and choose 1-N setup it does not allow me. This is a temp solution till we move data to new array.

Any help would be appreciated.
Thanks

No you can't. From the documentation:
"Primary arrays with only two controller nodes must use 2 IP and 2 FC links." So you could do an asynchronous\synchronous setup if one of your array pairs were close enough that you could use RCFC for one pair.