HPE Storage Users Group
https://3parug.com/

Adding 3PAR 7200c to RMC Recovery Manager Central
https://3parug.com/viewtopic.php?f=18&t=3856
Page 1 of 1

Author:  cenders [ Fri Nov 18, 2022 11:52 am ]
Post subject:  Adding 3PAR 7200c to RMC Recovery Manager Central

Hi everyone, new here... I've searched the forums and don't see anyone previously asking this question.

I'm using RMC 6.3.9 and am trying to add my 3PAR 7200c to the Storage Devices screen. I don't know which IP Address to give RMC, the ones I've tried don't seem to work. And I am selecting 3PAR as the device type that I'm adding.

The SAN IP address, the Service Processor, or, SSMC... I've tried them all with various credentials.

Can someone please point me in the right direction, I am desperate.

Thank you in advance.

Author:  cenders [ Fri Nov 18, 2022 1:16 pm ]
Post subject:  Re: Adding 3PAR 7200c to RMC Recovery Manager Central

Well, I've been searching for hours, pulling my hair out, to find the answer.  I finally found it.  No mention of this anywhere in the RMC documentation.

On the 3PAR, the WSAPI service needs to be enabled.  The correct IP to use is the SAN itself, not the Service Processor, nor the SSMC IP.  

To enable the WSAPI service, go into SSMC, under Storage Systems, and select the 3PAR.  Under the actions menu, click Edit.  On the next page, scroll down to WSAPI and Enable the service.  In my case, HTTPS was already enabled, but the service was disabled.

Author:  MammaGutt [ Sat Nov 19, 2022 3:01 am ]
Post subject:  Re: Adding 3PAR 7200c to RMC Recovery Manager Central

In CLI, run startwsapi

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/