HPE Storage Users Group
https://3parug.com/

Anyone using Cisco MDS switches for their fiber backend?
https://3parug.com/viewtopic.php?f=18&t=3081		 Page 1 of 1
Author:  jbguy [ Wed Jan 16, 2019 4:15 pm ]
Post subject:  Anyone using Cisco MDS switches for their fiber backend?
I have 2 new Cisco MDS 9148S switches that I need to put in. I didnt know anything about them but it was a good learning experience. Im 99% sure everything is as it should be but Im confused on one point.

Anyone using these switches? Should be a simple question for anyone who uses them.

Thanks!
Author:  MammaGutt [ Thu Jan 17, 2019 2:20 am ]
Post subject:  Re: Anyone using Cisco MDS switches for their fiber backend?
I try to stay away from them as much as possible.

Remember to enable npiv before you connect the 3PAR because it is disabled by default and require the port to go down/up to enable the change.
Author:  jbguy [ Thu Jan 17, 2019 12:07 pm ]
Post subject:  Re: Anyone using Cisco MDS switches for their fiber backend?
MammaGutt wrote:
I try to stay away from them as much as possible.

Remember to enable npiv before you connect the 3PAR because it is disabled by default and require the port to go down/up to enable the change.


Thanks for the tip. I already had it enabled but i double checked to be sure. These switches would not have been my first choice but they were here before I arrived. It sucked to have to learn a whole other device OS to get these programmed. No GUI is kind of a bummer as well.

Thanks again for the response.
Author:  Marc.mvh.vanhoof [ Fri Jan 18, 2019 11:06 am ]
Post subject:  Re: Anyone using Cisco MDS switches for their fiber backend?
Using the big CISCO MDS 9710 ..... No issues with 3par 8450 and 20850. <stop>
Author:  Richard Siemers [ Sat Jan 19, 2019 1:16 am ]
Post subject:  Re: Anyone using Cisco MDS switches for their fiber backend?
The Cisco GUI is the "device view" inside Cisco DCNM (formerly known as DFM), equivalent to BNA.

Grats on learning the other flavor of SAN switching, knowing both Brocade and Cisco is good for many reasons, and few get the opportunity.
Author:  markinnz [ Sun Jan 20, 2019 4:12 pm ]
Post subject:  Re: Anyone using Cisco MDS switches for their fiber backend?
Yup .. ours is a Cisco based SAN for the AC powered arrays and Brocade for the DC powered .. whats your question ?
- Ciscos are my favourite :-)
Author:  jbguy [ Wed Jan 23, 2019 4:16 pm ]
Post subject:  Re: Anyone using Cisco MDS switches for their fiber backend?
Thanks for the info everyone. Appreciate the tip Richard on using DCNM. That would have saved me a lot of time. Its good to see it all in a GUI.

Markinnz I will shoot you a PM with a question or two. Thanks!
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/