HPE Storage Users Group
https://3parug.com/

Port listed as host path but is State:ready, Mode:initiator
https://3parug.com/viewtopic.php?f=18&t=2245		 Page 1 of 1
Author:  glanzmann [ Fri Oct 21, 2016 4:18 am ]
Post subject:  Port listed as host path but is State:ready, Mode:initiator
Hello,
after reconfiguring two ports from being host ports to be rcfc ports, checkhealth -detail shows:

Quote:
Port port:0:2:2 Port listed as host path but is State:ready, Mode:initiator and Type:rcfc
Port port:1:2:2 Port listed as host path but is State:ready, Mode:initiator and Type:rcfc


Any idea how to get rid of these or should I open a call with HPE? Btw. I checked with showrcopy that the rcopy links are up and in use. I waited 3 days before writing this post, but I did not try
to reboot the 3PAR.

Cheers,
Thomas
Author:  RitonLaBevue [ Sat Oct 22, 2016 3:14 am ]
Post subject:  Re: Port listed as host path but is State:ready, Mode:initia
Before setting a port as RCFC port you must define the right zoning.
Remove nay zone involving host wwn and these ports.
Then configure ports on both array and initialize them : "controlport rcfc init -f 0:2:2"
Author:  tcolbert [ Wed Jun 07, 2017 4:28 am ]
Post subject:  Re: Port listed as host path but is State:ready, Mode:initia
Hi,
Did you ever resolve this and if so, how?

Thanks,

Trevor.
Author:  cali [ Thu Nov 12, 2020 8:48 am ]
Post subject:  Re: Port listed as host path but is State:ready, Mode:initia
Update for anybody who gets this error.
Assuming, that RCFC is properly configured and Zoning is correct (Only the 2 RCFC Ports in the Zone).

The Issue is, that the Array holding a List of all Hosts ever seen on the Ports.
The message says, that on these ports Hosts are seen (also in the past), but it is an RCFC port that should not see Hosts.

Check the Host list with: servicehost list
Cleanup all old Hosts with: servicehost remove [-f 0:2:2]

Then it is gone.

Cali
Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/