HPE Storage Users Group https://3parug.com/ |
|
Scripting - CLI on HP-UX https://3parug.com/viewtopic.php?f=17&t=468 |
Page 1 of 1 |
Author: | dsb0 [ Wed Nov 06, 2013 11:14 am ] |
Post subject: | Scripting - CLI on HP-UX |
First Post - New to 3Par moving from XP12000. All systems are HP-UX Writing the Pre and Post exec scripts for my weekly Cold backup. Got most of it working with 1 exception. The initial sync of the Physical copy. When I issue the commands in a script for each (59) virtual volumes to pair with it's physical copy, the first 10-12 say starting or queuing, then it gives me the following message "Error: VV namaca158_prd_sapdata1.0 is currently busy. Please try this operation after a while" (this is the original Base volume in the message no the physical copy volume) It gives this message 5-8 times then starts/queues a couple more then more Busy messages. If I cut and paste the same commands all at once into the CLI attched directly to the 3par using PuTTy it accepts them all and will run/queue them all but issuing them individually in a shell script it won't. Any Help would be greatly appreciated. Thanks, Dave B. |
Author: | dsb0 [ Sat Nov 09, 2013 9:33 pm ] |
Post subject: | Re: Scripting - CLI on HP-UX |
Found additional information These timeout errors only happen when the "Remote Copy Task" is active to our Disaster recovery Site. Opening a Case with HP on Monday. Will Post results. Thanks, dsb0 |
Author: | dsb0 [ Thu Dec 19, 2013 9:15 am ] |
Post subject: | Re: Scripting - CLI on HP-UX |
Reply from HP is: "That is going to happen. You need to code for this and retry the commands that fail". Not exactly what I was looking for but it's a work around. Dave |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |