HPE Storage Users Group
https://3parug.com/

Moved 3PAR unsure how to re-ip nodes
https://3parug.com/viewtopic.php?f=18&t=2793
Page 1 of 1

Author:  jbguy [ Wed Feb 07, 2018 2:56 pm ]
Post subject:  Moved 3PAR unsure how to re-ip nodes

Good afternoon all.

We moved our 3par to a new location but aside from the service processor im not 100% sure how to reip the nodes themselves so they can talk and be seen by the physical service processor.

Am I missing something as to how to do that? I havent been able to find any documentation on it.

Author:  jbguy [ Wed Feb 07, 2018 3:24 pm ]
Post subject:  Re: Moved 3PAR unsure how to re-ip nodes

FYI I have this for setting the Service processor ip

1. Set the new IP and netmask
setnet startaddr <old_IP> <new_IP> <new_netmask>

2. Set the new gateway
setnet startgateway <new_gateway>

3. Commit the changes
setnet finish [-f]

Author:  MammaGutt [ Wed Feb 07, 2018 4:03 pm ]
Post subject:  Re: Moved 3PAR unsure how to re-ip nodes

That is the commands for the 3PAR itself, not the service processor.

Author:  jbguy [ Wed Feb 07, 2018 4:36 pm ]
Post subject:  Re: Moved 3PAR unsure how to re-ip nodes

MammaGutt wrote:
That is the commands for the 3PAR itself, not the service processor.

ah ok, is there a good reference for that i can look at somewhere? not really sure how best to proceed . Would SPOCC be best for the SP itself? Console cable in?

Author:  MammaGutt [ Wed Feb 07, 2018 5:01 pm ]
Post subject:  Re: Moved 3PAR unsure how to re-ip nodes

For 3PAR, CLI or SSH.

For SP I think you can use both web, ssh and console(very nice if virtual). I've only used console.

As for reference, you have the CLI reference for 3PAR, sounds like a good match :)

Page 1 of 1 All times are UTC - 5 hours
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/