HPE Storage Users Group https://3parug.com/ |
|
Force IP change administrator https://3parug.com/viewtopic.php?f=18&t=2687 |
Page 1 of 1 |
Author: | Raul Valdivieso [ Wed Oct 18, 2017 11:12 am ] |
Post subject: | Force IP change administrator |
Hello All. I have a problem to change to the ip of administration, I throw the following message: "only one ip address can be changed at a time" . This ip change process will have to be via cable console? |
Author: | RitonLaBevue [ Thu Oct 19, 2017 1:36 am ] |
Post subject: | Re: Force IP change administrator |
Hello, Of course, no. How do you proceed to change the ip address ? setnet startaddr <old ip> <new ip> <new netmask> setnet startgateway <new gateway> setnet finish -f |
Author: | Raul Valdivieso [ Thu Oct 19, 2017 1:44 pm ] |
Post subject: | Re: Force IP change administrator |
If the process applied was that described in the user guide and the one you mention. However when entering the mentioned syntax the message remains: only one ip address can be changed at a time. most likely, is that you have to perform the process from the console port. |
Author: | MammaGutt [ Fri Oct 20, 2017 3:32 am ] |
Post subject: | Re: Force IP change administrator |
It almost seems like the system is already in the process of changing the IP address and you are unable to change more than 1 IP per go. What does shownet output? I've used the process multiple times via SSH and it works. |
Author: | Raul Valdivieso [ Fri Oct 20, 2017 12:54 pm ] |
Post subject: | Re: Force IP change administrator |
Hello Mamma Gut at the time of execution shownet, shows the same IPs without reflecting the changes entered through the commands: setnet startaddr <old ip> <new ip> <new mask> the process I'm doing via putty by ssh. I think I will have to do it via console cable |
Author: | MammaGutt [ Sat Oct 21, 2017 2:55 am ] |
Post subject: | Re: Force IP change administrator |
Try "help setnet" too see if you have a command to cancel current ongoing changes, if not do setnet finish and hope it hasn't accepted any changes, then try again. |
Author: | Raul Valdivieso [ Mon Oct 23, 2017 9:37 am ] |
Post subject: | Re: Force IP change administrator |
Hello use the command: "setnet abort" and with that the problem was solved and the change of IP was made. Thanks for the support. |
Page 1 of 1 | All times are UTC - 5 hours |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |